MXBON 11277 THREAD LOCKER

Registered to NSF Category S6 for use as a thread locking where there is no possibility of food contact in and around food processing areas. Note: This is a regional approval. Please contact your local Technical Service Center for more information and clarification.

Adhesive Properties - Torque

Cured for 24 hrs @ 25 ℃, Unseated

Breakaway Torque, ISO 10964:

Bonding Identical Substrate	N․m	lb.in
M10 steel nuts and bolts	32	282

Prevail Torque, ISO 10964:

Bonding Identical Substrate	N․m	lb.in.
M10 steel nuts and bolts	32	282

Adhesive Properties - Shear Strength​

After 24 hours @ 25 ℃

Compressive Shear Strength, ISO 10123:

	N/mm2	psi
Steel pins and collars	≧ 9	1,305

​​​​​​

Cured for 1 week @ 25 ℃

Breakloose Torque, ISO 10964, Pre-torque to 5 N․m

M10 zinc phosphate steel nuts and bolts

Aged at temperature indicated and tested @ 25 ℃

Aged under conditions indicated and tested @ 25 ℃

Environment	℃	500 h	1000h	5000h
Unleaded Petrol	25	100	100	95
Water/ethylene glycol 50/50	87	95	90	90
IPA	25	85	80	80
Acetone	25	90	90	85

 

This product is not recommended for use in pure oxygen and/or oxygen rich systems and should not be use with chlorine or other strong oxidizing materials. Where washing systems are used to clean the surfaces before bonding, it is important to check the compatibility of the washing solution with the adhesive. In some cases, these solutions can affect the cure and performance of the adhesive. This product is not recommended for use on certain plastics. Users are recommended to confirm compatibility of the product with such substrates.

Keep adhesive in a cool and dry place. The storage temperature is recommended at 8 °C to 24 °C. For details, consult the Safety Data Sheet, (SDS). Shelf life is two years from the date of manufacture in the original container under the optimal conditions.

1. Avoid contact with skin and eyes.

2. If contact with skin, rinse with water.

3. If adhesive gets into eye, keep eye open and rinse with water thoroughly. Seek medical attention immediately.

4. Keep the material out of children’s reach.

For assembly

1. The substrate surfaces must be clean and free of grease.

2. Shake the product thoroughly before use.

3. If the cure speed is too slow, consider using activator.

4. Apply several drops to the nut & bolt.

5. Assemble and tighten as required.

6. To prevent the clogging of the bottle nozzle, do not let the tip touch the metal surfaces during application.

For disassembly & cleanup

1. Use localized heat (250 ℃) to nut and bolt, disassemble while hot.

2. Use a wire brush to clean the charred product.